EN 2606:2009 – Aerospace series – 60° interface for adaptors, threaded, with lockring – Geometric configuration

EN 2606:2009 - Aerospace series - 60° interface for adaptors, threaded, with lockring - Geometric configuration

1 Scope
This standard specifies the dimensional characteristics of the 60° interface for adaptors, threaded, with lockring, assembly with elastomer O-ring, for aerospace applications.
This standard applies to all adaptors, threaded, with lockring, assembled to EN 2607 and used in fluid systems with a nominal pressure of 28 000 kPa for which a metric-size coupling with a 60° conical sealing surface has been selected.
2 Normative references
The following referenced documents are indispensable for the application of this document. For dated
references, only the edition cited applies. For undated references, the latest edition of the referenced
document (including any amendments) applies.
ISO 5855-1, Aerospace — MJ threads — Part 1: General requirements.
ISO 5855-3, Aerospace — MJ threads — Part 3: Limit dimensions for fittings for fluid systems.
EN 2602, Aerospace series — Ports for adaptors, threaded, with lockring — Geometric configuration.
EN 2603, Aerospace series — Port ends for adaptors, threaded, with lockring — Geometric configuration.
EN 2607, Aerospace series — O-rings for adaptors, threaded, with lockring — Survey.
3 Required characteristics
3.1 Configuration — Dimensions
According to Figure 1 and Table 1.
EN 2606:2009 – Aerospace series – 60° interface for adaptors, threaded, with lockring – Geometric configuration

Leave a Reply

Your email address will not be published. Required fields are marked *