BS EN ISO 10438-3:2007 – Petroleum, petrochemical and natural gas industries — Lubrication, shaft-sealing and control-oil systems and auxiliaries — Part 3: General-purpose oil systems

BS EN ISO 10438-3:2007 - Petroleum, petrochemical and natural gas industries — Lubrication, shaft-sealing and control-oil systems and auxiliaries — Part 3: General-purpose oil systems

1 Scope
This part of ISO 1 0438, in conjunction with ISO 1 0438-1 , specifies requirements for oil systems for generalpurpose applications. These oil systems can provide lubrication oil, but not seal oil and can serve equipment such as compressors, gears, pumps and drivers.
NOTE The term ―general-purpose‖ is defined in ISO 1 0438-1 .
2 Normative references
The following referenced documents are indispensable for the application of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
ISO 1 0438-1 :2007, Petroleum, petrochemical and natural gas industries — Lubrication, shaft-sealing and control-oil systems and auxiliaries — Part 1: General requirements
ISO 1 0438-2:2007, Petroleum, petrochemical and natural gas industries — Lubrication, shaft-sealing and control-oil systems and auxiliaries — Part 2: Special-purpose oil systems
ISO 1 3706:2005, Petroleum, petrochemical and natural gas industries — Air-cooled heat exchangers
ISO 1 3709, Centrifugal pumps for petroleum, petrochemical and natural gas industries
ISO 1 5649:2001 , Petroleum and natural gas industries — Piping
ISO 1 6889, Hydraulic fluid power — Filters — Multi-pass method for evaluating filtration performance of a filter element1 )
API RP 686, Machinery Installation and Installation Design
IEC 60034 (all parts), Rotating electrical machines
TEMA, Standards of the Tubular Exchanger Manufacturers Association NEMA MG1 , Motors and Generators
3 Terms, abbreviated terms and definitions
For the purposes of this document, the terms, definitions and abbreviated terms given in ISO 1 0438-1 apply.
4 General
4.1 Basic design
4.1.1 This part of ISO 1 0438 covers general-purpose oil systems. Typical datasheets for general-purpose oil systems are in Annex A. Typical piping and instrument diagrams for general-purpose oil systems are in Annex B. Typical inspector checklists for general-purpose oil systems are in Annex C. General-purpose (GP) oil systems are divided into classes and are defined by a coding system that defines the major components supplied (see Table 1 ). The user shall choose the applicable class and code based upon the required minimum reliability targets for the equipment train. Various API standards have supplied minimum recommended systems as indicated in Table 2 for their equipment. Annex D is supplied as a reference to provide guidance on the selection of a system.
BS EN ISO 10438-3:2007 – Petroleum, petrochemical and natural gas industries — Lubrication, shaft-sealing and control-oil systems and auxiliaries — Part 3: General-purpose oil systems

Leave a Reply

Your email address will not be published. Required fields are marked *