www.freestandardsdocuments.com collects the introduction about EN standards.The information will give you some guidance, remember to support my website.

BS EN 14569:2004 – This is an uncontrolled copy. Ensure use of the most current version of this document by searching British Standards Online at bsonline.techindex.co.uk

BS EN 14569:2004 - This is an uncontrolled copy. Ensure use of the most current version of this document by searching British Standards Online at bsonline.techindex.co.uk

Samples that are identified as having high endotoxin levels but low levels or no detectable GNB show an unusual microbiological profile. Thus, when log 1 0 EU/g – log 1 0 cfu GNB/g is greater than 0 the sample is suspected of having been irradiated and should be subjected to further radiation specific tests. Samples that are identified as having […]

Continue reading »

BS EN 14474:2004 – Precast concrete products — Concrete with wood-chips as aggregate — Requirements and test methods

BS EN 14474:2004 - Precast concrete products — Concrete with wood-chips as aggregate — Requirements and test methods

1 Scope This document specifies common requirements for wood-chip concrete, used in precast wood-chip concrete products. It is intended to be used when preparing documents for wood-chip concrete products. Wood-chip concrete product standards will define specific requirements, which may be additional to those given in this document. Product standards will give any limiting values. Examples for the use of wood-chip […]

Continue reading »

BS EN 14387:2004 – Respiratory protective devices — Gas filter(s) and combined filter(s) — Requirements, testing, marking

BS EN 14387:2004 - Respiratory protective devices — Gas filter(s) and combined filter(s) — Requirements, testing, marking

1 Scope This European Standard refers to gas filters and combined filters for use as components in unassisted respiratory protective devices. Filters for use against CO are excluded from this standard. Laboratory tests are included for the assessment of compliance with the requirements. Some filters complying with this standard can also be suitable for use with assisted respiratory protective devices […]

Continue reading »

BS EN 14316-1:2004 – Thermal insulation products for buildings — In- situ thermal insulation formed from expanded perlite (EP) products — Part 1: Specification for bonded and loose-fill products before installation

BS EN 14316-1:2004 - Thermal insulation products for buildings — In- situ thermal insulation formed from expanded perlite (EP) products — Part 1: Specification for bonded and loose-fill products before installation

1 Scope This document specifies the requirements covering the four product types of expanded perlite products Perlite Aggregate (EPA), Coated Perlite (EPC), Hydrophobic Perlite (EPH) and Premixed Perlite (EPM), containing less than 1 % organic material as defined by annex D for in-situ insulation of roofs, ceilings, walls and floors. This document is a specification for the insulation products before […]

Continue reading »

BS EN 14185-1:2003 – Non-fatty food — Determination of N-methylcarbamate residues — Part 1: HPLC-method with SPE clean-up

BS EN 14185-1:2003 - Non-fatty food — Determination of N-methylcarbamate residues — Part 1: HPLC-method with SPE clean-up

1 Scope This European Standard specifies a high performance liquid chromatographic (HPLC) method for the determination of N-methylcarbamate pesticides in cereals, fruits and vegetables. The method has been validated by collaborative study for carbaryl, carbofuran, methiocarb, methomyl, oxamyl and propoxur parent compounds and for methiocarb sulfoxide in green peppers and apples at levels between 0,08 mg/kg and 0,9 mg/kg. No […]

Continue reading »

BS EN 14079:2003 – Non-active medical devices — Performance requirements and test methods for absorbent cotton gauze and absorbent cotton and viscose gauze

BS EN 14079:2003 - Non-active medical devices — Performance requirements and test methods for absorbent cotton gauze and absorbent cotton and viscose gauze

1 Scope This standard describes the requirements and test methods for absorbent cotton gauze and absorbent cotton and viscose gauzes. The standard does not consider gauzes impregnated with a pharmaceutical substance. 2 Normative references This standard contains no normative references 3 Terms and definitions For the purposes of this European Standard the following terms and definitions apply: 3.1 absorbent cotton […]

Continue reading »

BS EN 13810-1:2002 – Wood-based panels — Floating floors — Part 1: Performance specifications and requirements

BS EN 13810-1

1 Scope This European Standard provides the performance specifications and requirements for wood-based panels used in continuously fully supported non-structural floating floors. 2 Normative references This European Standard incorporates by dated or undated reference, provisions from other publications. These normative references are cited at the appropriate places in the text, and the publications are listed hereafter. For dated references, subsequent […]

Continue reading »

BS EN 13760:2003 – Automotive LPG filling system for light and heavy duty vehicles — Nozzle, test requirements and dimensions

BS EN 13760:2003 - Automotive LPG filling system for light and heavy duty vehicles — Nozzle, test requirements and dimensions

1 Scope This European Standard specifies the minimum design, construction, test requirements and the critical dimensions for filling nozzles for the dispensing of automotive Liquefied Petroleum Gas (LPG) to vehicles of categories M and N, as defined in EC Directive 70/156, that are fitted with the Euro filling unit (light duty or heavy duty). 2 Normative references This European Standard […]

Continue reading »

BS EN 13756:2002 – Wood flooring — Terminology

BS EN 13756:2002 - Wood flooring — Terminology

1 General trms horizontal structure within a building comprising the_ primary structure and/or the sub-floor and the flooring assembly of individual wood elements installed either on the primary strucure or on the subfloor non-continuous/continuous support system between the wood flooring and the primary structure wood flooring with a top layer thickness of minimum 2,5 mm prior to installation (conventional definition) […]

Continue reading »

BS EN 13622:2002 – This is an uncontrolled copy. Ensure use of the most current version of this document by searching British Standards Online at bsonline.techindex.co.uk

BS EN 13622:2002 - This is an uncontrolled copy. Ensure use of the most current version of this document by searching British Standards Online at bsonline.techindex.co.uk

2 Terms and deflntions 2.1 Group 1: Terms relating to hoses, hose assemblles and 8ssembled hoses 2.1.1 qulick-action cupling with shut-off valve a device enabling a rapid coupling or uncoupling under pressure of two elements and/or hoses, which automatically releases the gas flow during connection and prevents the escape of gas when disconnected 2.1.2 hose assembly an assembly consisting of […]

Continue reading »
1 44 45 46 47 48 56