Category: EN standards

1 Scope This European Standard specifies functional requirements (see Clause 3) and safety requirements (see Clause 4) for basketball equipment. This European Standard is applicable to 8 types of basketball equipment within the classes A to E (see 3.1). This European Standard is not applicable to home basketball equipment, which is considered to be covered by EN 71-1, and to […]

1 Scope This part of ISO 21078 specifies procedures of chemical analysis for the determination of boron(III) oxide used as a binder component added to aluminosilicate refractories, using an acid extraction method. It is applicable for refractories containing less than (mass fraction) of boron(III) oxide. 2 Normative references The following referenced documents are indispensable for the application of this document. […]

1 Scope This International Standard specifies a method for the determination of benzo[a]pyrene in crude or refined edible oils and fats by reverse-phase high-performance liquid chromatography (HPLC) using fluorimetric detection in the range from 0,1 µg/kg to 10 µg/kg. 2 Normative reference The following standard contains provisions, which through reference in this text, constitute provisions of this International Standard. At […]

1 Scope This International Standard specifies requirements for classification of wire electrodes, wires and rods for gas- shielded metal arc welding, gas tungsten arc welding, plasma arc welding, submerged arc welding and laser beam welding of stainless and heat resisting steels. The classification of the wire electrodes, wires and rods is based upon their chemical composition. This document is a […]

1 Scope This part of ISO 11111 is intended to be used in conjunction with ISO 11111-1, ISO 11111-2, ISO 11111-6 and ISO 11111-7. It specifies significant hazards and corresponding safety requirements and/or measures for nonwoven machinery. By taking into account the scope of ISO 11111-1 as far as is relevant, this part of ISO 11111 is applicable to all […]

1 Scope This part of ISO 1 0438, in conjunction with ISO 1 0438-1 , specifies requirements for oil systems for generalpurpose applications. These oil systems can provide lubrication oil, but not seal oil and can serve equipment such as compressors, gears, pumps and drivers. NOTE The term ―general-purpose‖ is defined in ISO 1 0438-1 . 2 Normative references The […]

1 Scope This International Standard specifies the principal electrical and optical parameters for a consumer audio/video equipment digital interface that uses plastic optical fibre (POF). NOTE A description of the principal features of such an interface is given in Annex C. 2 Normative references The following referenced documents are indispensable for the application of this document. For dated references, only […]

5.3 Rated insulation level The rated insulation level for the cable connection assembly shall be selected from the values given in IEC 60038 (IEC standard voltages) as well as IEC 62271 -203:2003. 5.4 Rated normal current and temperature rise The connection interface of the main circuit shown in Figures 2 and 3 for fluid-filled cable- terminations and Figures 4 and […]

Two electrically shielded magnetic probes are clamped on one wires or a combination of wires that is/are connected to the device under test. The first probe is for the injection of RF power that induces I disturbance onto the wires. The second probe is used for monitoring the i nduced current on those wires. The disturbance current flows in a […]

The Local_wPort, Remote_wPort, Local_UDP_Port, Remote_UDP_Port, Local_IP_Address and Remote_IP_Address parameters carry the same values as the corresponding UDP- DATA.request service being confirmed. The value of the Result parameter indicates whether the COSEM UDP-based transport layer was able to send the requested UDP Datagram (OK) or not (NOK). Use If implemented, this service primitive is used to confirm the result of a […]