Introduction of national standards
BS 7499:2020 pdf free.Provision of static guarding security services—Code of practice. Where night-time working is involved, prospective employees should be asked to confirm that there Is nothing in their circumstances that would be detrimental to their working night shifts. Night-time workers should be offered a free medical assessment. NOTE I AUentson is drawn to the Working Time Amendment) Regulation 2003(21 […]
Continue reading »
BS 8406:2020 pdf free.Event stewarding – Code of practice. NOTE1 It is widely accepted that events stewarding is a wide-ranging discipline and can encompass types of events that can range from relatively small community-based events to highly complex events that command attention from a global audience. The organization should decide the level(s) of screening to be applied to the individual […]
Continue reading »
BS EN 73:2020 pdf free.Durability of wood and wood-based products – Accelerated ageing of treated wood prior to biological testing一Evaporative ageing procedure. Test specimens are prepared for biological testing against either fungi or insects using the appropriate standards methods. Test specimens are exposed, for a specified period, in a dust-free current of air of a defined velocity and temperature. Equipment […]
Continue reading »
BS EN 197-2:2020 pdf free,Cement Part 2: Assessment and verification of constancy of performance. 4.1.3.1 Quality policy statement The Works’ quality documentation shall include a statement by management defining its quality policy, objectives and commitments to the attainment of product quality. 4.1.3.2 Quality manager A quality manager shall be appointed who, irrespective of other responsibilities, shall have defined and adequate […]
Continue reading »
BS EN 84:2020 pdf free.Durability of wood and wood-based products一Accelerated ageing of treated wood prior to biological testing一Leaching procedure. The following documents are referred to in the text in such a way that some or all of their content constitutes requirements of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the […]
Continue reading »
BS EN 81-50:2020 pdf free.Safety rules for the construction and installation of lifts一Examinations and tests Part 50: Design rules, calculations, examinations and tests of lift components. These procedures are applicable to locking devices for landing and car doors. It is understood that each component taking part in the locking of doors and in the checking of the locking forms part […]
Continue reading »
BS EN ISO 15586:2003 pdf free.Water quality一 Determination of trace el ements using atomic absorption spectrometry with graphite furnace. Pre-treatment and analysis of samples with especially low element concentrations should be carried out under ‘clean laboratory” conditions. The mclean laboratory” technique requires that the laboratory be supplied with filtered air, and that the samples be continuously protected from contamination originating […]
Continue reading »
BS EN ISO 4628-7:2003 pdf free.Paints and varnishes- Evaluation of degradation of coatings一Designation of quantity and size of defects, and of intensity of uniform changes in appearance一 Part 7: Assessment of degree of chalking by velvet method. This part of ISO 4628 describes a method suitable, in particular, for rating the degree of chalking on white or coloured exterior coatings […]
Continue reading »
BS EN ISO 4628-4:2003 pdf free.Paints and varnishes – Evaluation of degradation of coatings一Designation of quantity and size of defects, and of intensity of uniform changes in appearance- Part 4: Assessment of degree of cracking. This part of ISO 4628 describes a method for assessing the degree of cracking of coatings by comparison with pictorial standards, using the designation system […]
Continue reading »
BS EN ISO 4628-3-2003 pdf free.Paints and varnishes一 Evaluation of degradation of coatings一Designation of quantity and size of defects, and of intensity of uniform changes in appearance一 Part 3: Assessment of degree of rusting. This part of ISO 4628 describes a method for assessing the degree of rusting of coatings by comparison with pictorial standards. The pictorial standards provided in […]
Continue reading »