BS EN ISO 11111-5:2005 – Textile machinery — Safety requirements — Part 5: Preparatory machinery to weaving and knitting

BS EN ISO 11111-5:2005 - Textile machinery — Safety requirements — Part 5: Preparatory machinery to weaving and knitting

1 Scope
This part of ISO 1 1 1 1 1 is intended to be used in conjunction with ISO 1 1 1 1 1 -1 . It specifies significant hazards and corresponding safety requirements and/or measures for preparatory machinery to weaving and knitting. By taking into account the scope of ISO 1 1 1 1 1 -1 as far as is relevant, this part of ISO 1 1 1 1 1 is applicable to all machinery, plant and related equipment intended to be used for warping, beaming, sizing, size preparation and storage of warp beams, as specified in Clause 5.
2 Normative references
The following referenced documents are indispensable for the application of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
ISO 9902-1 , Textile machinery — Noise test code — Part 1: Common requirements
ISO 9902-5, Textile machinery — Noise test code — Part 5: Weaving and knitting preparatory machinery
ISO 1 1 1 1 1 -1 :2005, Textile machinery — Safety requirements — Part 1: Common requirements
ISO 1 3852:1 996, Safety of machinery — Safety distances to prevent danger zones being reached by the upper limbs
IEC 60204-1 :2000, Safety of machinery — Electrical equipment of machines — Part 1: General requirementsm
3 Terms and definitions
For the purposes of this part of ISO 1 1 1 1 1 , the terms and definitions given in ISO 1 1 1 1 1 -1 apply.
4 List of significant hazards
Significant hazards found in preparatory machines to weaving and knitting which are common with those frequently occurring with other textile machines or with machine elements of other textile machines shall be considered in accordance with ISO 1 1 1 1 1 -1 :2005, Clauses 5 and 6, whenever referred to under the heading ―General safety requirements‖ in Clause 5 of this part of ISO 1 1 1 1 1 . Significant hazards which are particular to preparatory machines to weaving and knitting are considered as ―Specific hazards‖ in Clause 5 of this part of ISO 1 1 1 1 1 .
Before using this part of ISO 1 1 1 1 1 , it is important to carry out a check to ascertain that the specific machine has the significant hazards identified.
NOTE The significant hazards of preparatory machinery to weaving and knitting are always considered in conjunction with safety requirements.
5 Significant hazards and corresponding safety requirements and/or measures
5.1 General
Machinery shall conform to the safety requirements of ISO 1 1 1 1 1 -1 :2005, Clauses 5 and 6, whenever referred to under the heading ―General safety requirements‖ of this Clause 5 and shall conform to the additional ―Specific safety requirements‖ of this Clause 5.
5.2 Warping, beaming and assembly beaming machines
Including cone warping machines, sectional warping machines, beam warping machines, beaming machines,ssembly beaming machines, sectional beaming machines, sizing machine headstocks and other similar machinery.
General safety requirements
The safety requirements and/or measures shall be in accordance with Table 1 .
BS EN ISO 11111-5:2005 – Textile machinery — Safety requirements — Part 5: Preparatory machinery to weaving and knitting

Leave a Reply

Your email address will not be published. Required fields are marked *