BS EN 60384-23-1:2005 – Fixed capacitors for use in electronic equipment — Part 23-1: Blank detail specification — Fixed surface mount metallized polyethylene naphthalate film dielectric DC capacitors — Assessment level EZ
1 General data
1 .1 Recommended method(s) of mounting (to be inserted)
See 1 .4.2 of IEC 60384-23.
1 .2 Dimensions
When there is no case size reference, Table 1 may be omitted and the dimensions shall be given in Table 2, which then becomes Table 1 .
The dimensions shall be given as maximum dimensions or as nominal dimensions with a tolerance.
1 .3 Ratings and characteristics
Capacitance range (see Table 2)
Tolerance on rated capacitance
Rated voltage (see Table 2)
Category voltage (if applicable) (see Table 2)
Climatic category
Rated temperature
Max. AC voltage (if applicable)
Max pulse load (if applicable)
Tangent of loss angle
Insulation resistance
1 .4 Normative references
IEC 60384-1 :1 999, Fixed capacitors for use in electronic equipment – Part 1: Generic specification
IEC 60384-23, Fixed capacitors for use in electronic equipment – Part 23: Sectional specification 1 .5 Marking
The marking of the capacitor and the package shall be in accordance with the requirements of 1 .6 of IEC 60384-23.
The details of the marking of the component and package shall be given in full in the detail specification.
1 .6 Ordering information
Orders for capacitors covered by this specification shall contain, in clear or in coded form, the following minimum information:
a) rated capacitance;
b) tolerance on rated capacitance;
c) rated DC voltage;
d) number and issue reference of the detail specification and style reference;
e) packaging instructions.
1 .7 Certified records of released lots
Required/non required.
1 .8 Additional information (not for inspection purposes)
1 .9 Additional or increased severities or requirements to those specified in the generic or sectional specification
NOTE Additions or increased requirements should be specified only when essential.
BS EN 60384-23-1:2005 – Fixed capacitors for use in electronic equipment — Part 23-1: Blank detail specification — Fixed surface mount metallized polyethylene naphthalate film dielectric DC capacitors — Assessment level EZ