BS EN ISO 14923:2003 – Thermal spraying — Characterization and testing of thermally sprayed coatings

BS EN ISO 14923:2003 - Thermal spraying — Characterization and testing of thermally sprayed coatings

1 Scope
This European Standard gives guidance on tests used for characterizations of coatings produced by thermal spraying. It is not possible in this document to go into details regarding the different types of coatings and large numbers of coatings due to the fact that all meltable materials can be processed by thermal spraying and that so many and varied thermal spraying processes exist. The tests listed are procedures and test criteria in general use for thermally sprayed coatings. Test methods not mentioned here are only used in special cases or under laboratory conditions.
NOTE Continuous further development and technical improvements mean that this standard cannot make any claim to completeness.
2 Normative references
This European Standard incorporates by dated or undated reference, provisions from other publications. These normative references are cited at the appropriate places in the text, and the publications are listed hereafter. For dated references, subsequent amendments to or revisions of any of these publications apply to this European Standard only when incorporated in it by amendment or revision. For undated references the latest edition of the publication referred to applies (including amendments). EN 571-1, Non destructive testing — Penetrant testing — Part 1: General principles (identical with ISO/DIS 3452- 1:1996).
EN 582, Thermal spraying — Determination of tensile adhesive strength.
EN 623-2, Advanced technical ceramics — Monolithic ceramics — General and textural properties — Part 2:Determination of density and porosity.
EN 657, Thermal spraying — Terminology, classification.
EN 821-2, Advanced technical ceramics — Monolithic ceramics — Thermo-physical properties — Part 2:Determination of thermal diffusivity by the laser flash (or heat pulse) method.
EN 993-14, Methods of testing dense shaped refractory products — Part 14: Determination of thermal conductivity by the hot-wire (cross-array) method.
ENV 1071-1, Advanced technical ceramics — Methods of test for ceramic coatings — Part 1: Determination of coating thickness by contact probe profilometer.
EN 1071-2, Advanced technical ceramics — Methods of test for ceramic coatings — Part 2: Determination of coating thickness by the crater grinding method.
ENV 1071-3, Advanced technical ceramics — Methods of test for ceramic coatings — Part 3: Determination of adhesion by a scratch test.
ENV 1159-2, Advanced technical ceramics — Ceramic composites — Thermophysical properties — Part 2: Determination of thermal diffusivity.
EN 1274, Thermal spraying — Powders — Composition — Technical supply conditions.
EN 24624, Paints and varnishes — Pull-off test (ISO 4624:1978).
EN ISO 1463, Metallic and oxide coatings — Measurement of coating thickness — Microscopical method (ISO 1463:1982).
BS EN ISO 14923:2003 – Thermal spraying — Characterization and testing of thermally sprayed coatings

Leave a Reply

Your email address will not be published. Required fields are marked *